Oh No, Camera Not Connected? When adding cameras to the Peterbilt Retrofit or Kenworth Retrofit cameras must be enabled before viewing. There’s a very simple solution to getting them cameras enabled.
Continue reading “Troubleshooting SmartNav & NavPlus Installations”Category: Truck Navigation
How to Replace Peterbilt SmartNav
This article describes how to replace the SmartNav system in your Peterbilt truck. The SmartNav 2.0 Navigation system replaces the older SmartNav 1.0 system in any Peterbilt semi. Bypassing the factory installed SmartNav system may also be an option worth considering.
This is the very same system available through your local Pete dealer just at a lower cost to you. Each kit is specific to the truck model and features so choose carefully. Installation of the new system is pretty straight forward. Start by removing the old head-unit and touch screen. Remove obsolete wiring by unpluging the wires leading to the old head unit and monitor. Connect the new wiring included with the SmartNav 2.0 system and then connect the new equipment to the harness ends where appropriate. Detailed installation instructions are included in the box. Most folks can do this installation in just a few hours. A certified tech should have this job done inside of an hour.